Tried different hard drives with E-SATA, only 500 GB works! Not 2Tb, nor 1.5 Tb

hello,
sorry for my later,i was been very busy in the last weeks.
Yesterday i tryed to follow the cyrius guide. I used the Debian Testing (squeeze) . If i use the stable Lenny the HD was not detected.
Now the HD is detected,but debian not start and i have the follow error :

__ __ _ _
| \/ | __ _ _ ____ _____| | |
| |\/| |/ _` | '__\ \ / / _ \ | |
| | | | (_| | | \ V / __/ | |
|_| |_|\__,_|_| \_/ \___|_|_|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__|
** MARVELL BOARD: SHEEVA PLUG LE

U-Boot 1.1.4 (Jul 14 2009 - 06:46:57) Marvell version: 3.4.16

U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CF120

Soc: 88F6281 A0 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz

DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000 size 256MB
DRAM CS[1] base 0x10000000 size 256MB
DRAM Total size 512MB 16bit width
Flash: 0 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:512 MB

CPU : Marvell Feroceon (Rev 1)

Streaming disabled
Write allocate disabled

USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0

Reset IDE:
Marvell Serial ATA Adapter
Integrated Sata device found
[0 1 0]: Enable DMA mode
Device 1 @ 0 1:
Model: ST9250827AS Firm: 3.CTA Ser#: 5RG1A5NM
Type: Hard Disk
Supports 48-bit addressing
Capacity: 238475.1 MB = 232.8 GB (488397168 x 512)

** Bad partition 1 **
** Bad partition 1 **
## Booting image at 00800000 ...
Bad Magic Number
Marvell>>

Do you know why?
Thank you, Frank